ID2000 Series Industrial Code Reader User Manual
78
Set and Execute Self Trigger Mode
Self trigger allows you to trigger the device according to the trigger period you configured.
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select Self Trigger as Trigger Source, set Self Trigger Period and Self Trigger Count.
Figure 9-32 Set and Execute Self Trigger Mode
Note
●
If the self-trigger count is set to 0, and it means that it can be triggered indefinitely until
the execution of self-trigger stops.
●
The self-trigger time shall be set to be greater than the reciprocal of the actual frame rate.
Set and Execute Response Tigger
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select Response Trigger as Trigger Source, and set Trigger Sensitivity accordingly.
9.6.4 Stop Trigger
The device supports stopping trigger via TCP, UDP, I/O, serial port and USB. You can also
set code reading timeout duration or max. code amount to be read to stop trigger. After
stopping trigger is completed, the device cannot make response to trigger again.
Note
●
Type VII device supports stopping trigger via serial port, I/O, code reading timeout
duration or max. code amount.
To Next Page
Loading...
