ID2000 Series Industrial Code Reader User Manual
82
9.7 Signal Output Settings
9.7.1 Select Output Signal
The device’s output signal can control external devices like PLC, flashing light, etc. Click I/O
Control Settings → Output → Line Out Selector to select output signal.
Note
The specific output signals may differ by device models.
Figure 9-36 Select Output Signal
9.7.2 Enable Line Inverter
The line inverter function allows the device to invert the electrical signal level of an I/O line,
and meets requirements of different devices for high or low electrical signal level.
You can go to I/O Control Settings → Output → Line Out Inverter to enable it.
Note
The Line Out Inverter function is disabled by default.
Figure 9-37 Enable Line Out Inverter
To Next Page
Loading...