Note
●
Code 128 and 2D codes can be recognized no matter what kind of code color is configured.
●
PDF 417 of white code on black wall cannot be recognized if the code color is white code
or self-adaptive.
10.5 Set Setting Codes of Code Reading Quantity
You can set the device’s code reading quantity via scanning the specific setting codes as
shown below.
Steps
1. Read setting codes of editing quantity of code reading.
Figure 10-2 Edit Quantity of Code Reading
2. Read the corresponding digital codes according to actual demands.
Note
●
The quantity of code reading is related with code reading mode.
●
If the code reading mode is batch mode and the quantity of code reading is smaller than
or equal to 21, you should scan the digital code of tens digit first, and then scan the single
digit. If the quantity of code reading is single digit, the digital code of tens digit is 0. For
example, if the quantity of code reading is 12, scan the digital code of 1 first, and then
scan 2.
●
If the code reading mode is continuous mode, the quantity of code reading is not limited.
You should scan the digital code in the first place, and then scan the digital code in the
To Next Page
Loading...
