HikRobot ID2000 Series - Set TCP Server; Set Profinet; Set MELSEC;SLMP

ID2000 Series Industrial Code Reader User Manual
88
parameters:
Table 9-10 FTP Communication Protocol
Parameter
Description
FTP Protocol
If enabled, the code reader will output data via FTP server.
FTP Host Addr
IP address of the FTP host.
FTP Host Port
Port No. of the FTP host.
FTP User Name
User name of the FTP.
FTP User PWD
Password of the FTP.
9.8.5 Set TCP Server
If you select TCP Server as the communication protocol, you can configure the following
parameters:
Table 9-11 TCP Server Communication Protocol
Parameter
Description
TCP Server Enable
If enabled, the code reader will output data via TCP server.
TCP Server Port
The port No. of the TCP server that receives data outputted by code
reader.
9.8.6 Set Profinet
If you select Profinet as the communication protocol, you can configure the following
parameters:
Table 9-12 Profinet Communication Protocol
Parameter
Description
Profinet Enable
If enabled, the device will output data via Profinet protocol.
Profinet Device Name
Enter the name of the code reader, which is used for code
reader recognition in Profinet protocol communication.
9.8.7 Set MELSEC/SLMP
If you select Melsec/SLMP as the communication protocol, you can configure the following
parameters: