HikRobot ID2000 Series - Set Multicast

ID2000 Series Industrial Code Reader User Manual
89
Table 9-13 MELSEC/SLMP Communication Protocol
Parameter
Description
MELSEC Protocol Enable
If enabled, the code reader will output data via MELSEC
protocol.
MELSEC Server IP
IP address of the Programmable Logic Controller (PLC)
connected to the code reader.
MELSEC Server Port
Port number of the Programmable Logic Controller (PLC)
connected to the code reader.
MELSEC Frame Type
Frame type of the MELSEC.
MELSEC Network Number
Network number to communicate with.
MELSEC Node Number
Node number to communicate with.
MELSEC Processer Number
Processor number to communicate with.
MELSEC Control Poll
Interval
Requested time between successive polls of the control
block from the PLC.
MELSEC Control Space
It sets storage space of the control area.
MELSEC Control Offset
It sets the start offset address of the control area.
MELSEC Control Size
(Word)
It sets the size of the control area.
MELSEC Status Space
It sets storage space of the status area.
MELSEC Status Offset
It sets the start offset address of the status area.
MELSEC Status Size (Word)
It sets the size of the status area.
MELSEC Result Space
It sets storage space of the result area.
MELSEC Result Offset
It sets the start offset address of the result area.
MELSEC Result Size (World)
It sets the size of the result area.
MELSEC Result Byte Swap
If it is enabled, the client software will swap MELSEC
results.
MELSEC Result Timeout
It sets the MELSEC result timeout, and the unit is s.
9.8.8 Set Ethernet/IP
If you select EthernetIp as the communication protocol, you can configure the following
parameters: