HikRobot ID2000 Series - Device with RS-232 Interface

ID2000 Series Industrial Code Reader User Manual
21
The supplied cable also has four open lines with different colors, and you can wire them
according to actual demands.
Table 4-8 Open Line Definitions
No.
Signal
I/O Signal Source
Description
Color
1
OPTO_OUT0
LineOut 3
Non-isolated Output
Brown
2
OPTO_IN0
LineIn 1
Non-isolated Input
Yellow
3
GPIO1
Line 2
It can be configured as input
or output via the client
software
Orange
4
GND
--
Direct Current Power Supply
Ground
Black
4.3 Device with RS-232 Interface
Type VII device with RS-232 interface has a cable with 10-pin RJ45 female connector. It is
recommended to use the supplied cable, as shown below, in the package when using the
device. The supplied cable has a RJ45 male connector for connecting the device, and a DB9
interface for connecting external devices.
Figure 4-13 Cable for Type VII Device with RS-232 Interface
The supplied cable also has five open lines with different colors, and you can wire them
according to actual demands.
Table 4-9 Open Line Definitions
No.
Signal
I/O Signal Source
Description
Color
1
OPTO_OUT0
LineOut 3
Non-isolated Output
Brown
2
OPTO_IN0
LineIn 1
Non-isolated Input
Orange
3
GPIO1
Line 2
It can be configured as input or
output via the client software
Yellow
4
VCC
--
Direct Current Power Supply
Positive
Red
5
GND
--
Direct Current Power Supply
Ground
Black