HikRobot ID2000 Series - Set TCP Client; Set Serial; Set FTP

ID2000 Series Industrial Code Reader User Manual
87
Table 9-7 SmartSDK Communication Protocol
Parameter
Description
SmartSDK Protocol
If enabled, the device will output data via SmarkSDK.
Encode JPEG Flag
The device will compress images in JPG format after enabling it.
Quantity of JPG
It sets the image compression quality, and it ranges from 50 to 99.
9.8.2 Set TCP Client
If you select TCP Client as the communication protocol, you can configure the following
parameters:
Table 9-8 TCP Client Communication Protocol
Parameter
Description
TCP Protocol
If enabled, the device will output data via the TCP server.
TCP Dst Addr
Enter the IP address of the server that receives data outputted by the
code reader.
TCP Dst Port
Enter the port No. of the server that receives data outputted by the
code reader.
9.8.3 Set Serial
If you select Serial as the communication protocol, you can configure the following
parameters:
Table 9-9 Serial Communication Protocol
Parameter
Description
Serial Protocol
If enabled, the code reader will output data via serial port.
Serial Baudrate
The baud rate of the serial port of the PC that receives data.
Serial Data Bits
Data bits of the serial port of the PC that receives data.
Note
The hexadecimal trigger is supported only when Serial Data Bits is 8.
Serial Parity
Parity bits of the serial port of the PC that receives data.
Serial Stop Bits
Stop bits of the serial port of the PC that receives data.
9.8.4 Set FTP
If you select FTP as the communication protocol, you can configure the following