HikRobot ID2000 Series - Reboot Device

ID2000 Series Industrial Code Reader User Manual
117
Function
Setting Codes
Function
Setting Codes
Set Delay
Time 1 s
Set Delay
Time 2 s
Set Delay
Time 5 s
Set Delay
Time 10 s
10.8 Set Setting Codes of Light Source
The setting codes of light source can enable or disable the light source, set polling interval,
etc. After enabling Light Polling, you can let red and while light sources polling alternately
in accordance with configured interval when code reading succeeds or before ending trigger.
Note
● By default, the polling interval is 2 s.
● The supported setting codes of light source may differ by device models.
Table 10-11 Set Setting Codes of Light Source
Function
Setting Codes
Function
Setting Codes
Enable White
Light
Disable White
Light
10.9 Set Setting Codes of Buzzer
The setting codes of buzzer can enable or disable the buzzer function, set its duration, etc.
Note
The supported setting codes of buzzer may differ by device models.