ID2000 Series Industrial Code Reader User Manual
85
Figure 9-41 Select Compare Fail
Select Command Control IO
If you select Command Control IO as Line Out Activation Event, and you do not need to set
any parameters.
●
Control Start Str: It sets the start string of command control.
●
Control Stop Str: It sets the stop string of command control.
●
Line Out Delay Time: It sets the delay time for outputting the output signal.
●
Line Out Duration: It sets the time duration of the output signal.
Figure 9-42 Select Command Control IO
9.7.4 Set Buzzer
Note
●
Only type VI and type VII devices support buzzer function.
●
Make sure that the device is the Normal mode before using the buzzer function.
The buzzer is used to indicate the device’s operation status, and you can set the buzzer
function according to actual demands.
To Next Page
Loading...
