HikRobot ID2000 Series - Input Signal Wiring

ID2000 Series Industrial Code Reader User Manual
27
Table 6-2 Output Electrical Feature
Parameter Name
Symbol
Value
Output Logic Level Low
VL
730 mV
Output Logic Level High
VH
3.2 VDC
Output Falling Delay
TDF
6.3 μs
Output Rising Delay
TDR
68 μs
Output Falling Time
TF
3 μs
Output Rising Time
TR
60 μs
6.1.3 Input Signal Wiring
The device can receive the external input signal, and this section introduces input signal
wiring.
Note
● Input signal wiring may differ by external device types.
● The supplied 17-pin cable of type V device has pull-up and pull-down resistors.
● The voltage of VCC should be equal to or less than that of PWR. Otherwise, the output
signal exception may occur.
PNP Device
Opto-isolated
Input
DB9 Connector
Input Signal Ground
PNP
Device
PNP Device Power
PNP Power Ground
Signal Line
VCC
GND of PWR
GND of VCC
Figure 6-5 Input Signal Connecting to PNP Device
NPN Device
If the VCC of NPN device is 12 VDC or 24 VDC, and the pull-up resistor of the supplied 17-
pin cable is used.