ID2000 Series Industrial Code Reader User Manual
66
Figure 9-19 Create Chessboard ROI
3. Click after creating ROI, and the red frame becomes green as shown below.
Figure 9-20 Draw ROI via Chessboard
4. (Optional) Click to restore the ROI to full screen, and click to clean all ROIs.
5. Repeat other optional steps mentioned in drawing single group of ROI.
Note
The figures above are for reference only, and refer to the actual conditions.
9.4.3 Set Algorithm Parameter
In Algorithm Parameter, select 1DCode, 2DCode or Stacked Code as Arithmetic Type, and
then you can set its corresponding parameters.
Note
●
You should have selected at least one type of 1D code, 2D code or stacked code.
●
For different models of the device, the specific parameters may differ, and the actual
device you purchased shall prevail.
To Next Page
Loading...
