ID2000 Series Industrial Code Reader User Manual
107
Chapter 10 Setting Codes
10.1 Introduction
The device supports configuring parameters via reading special codes that are called
setting codes. Here we introduce common setting codes.
Note
●
Type VI and type VII devices support the function of setting codes.
●
Before using other setting codes, you need to scan Enable Setting Codes first to activate
the function of setting codes.
Figure 10-1 Setting Codes Introduction
Table 10-1 Device Mode Description
It is the code part of the setting code. After reading this part,
the device can finish the corresponding parameter settings.
**stands for the default settings.
It is the content of setting codes.
Via reading setting codes, the device can set enable/disable settings, set code type, set
quantity of code reading, set data processing, set aiming system, set light source, set serial
port, etc.
10.2 Enable/Disable Setting Codes
Before using other setting codes, you need to scan Enable Setting Codes first to activate
the function of setting codes. Scan Disable Setting Codes to exit setting codes function.
To Next Page
Loading...
