HikRobot ID2000 Series - Device with USB Interface

ID2000 Series Industrial Code Reader User Manual
19
4.2 Device with USB Interface
Device with USB interface includes type I device to type VII device.
Type I to Type V Devices
Type I, type II, type III, type IV and type V devices all have a 17-pin M12 connector. Refer to
the figure and table below for connector pin definitions.
Figure 4-8 17-Pin M12 Connector
Table 4-6 Pin Definitions (Type I to Type V Devices)
No.
Signal
I/O Signal Source
Description
1
DC_PWR
--
Direct Current Power Supply Positive
3
USB_DM
--
USB Signal Negative
11
GND
--
Direct Current Power Supply Negative
12
USB_DP
--
USB Signal Positive
You should use the supplied cable to wire the device. The cable has a 17-pin M12 connector
for connecting with the device, and a USB interface for connecting with the PC.
Figure 4-9 17-Pin Cable for Type I to Type V Devices