HikRobot ID2000 Series - I;O Electrical Feature and Wiring of Other Devices

ID2000 Series Industrial Code Reader User Manual
20
Type VI Device
Type VI device has a DB15 connector. Refer to the figure and table below for connector pin
definitions.
Figure 4-10 DB15 Connector
Table 4-7 Pin Definitions (Type VI Device)
No.
Signal
I/O Signal Source
Description
4
GND
--
Direct Current Power Supply Negative
9
POWER_5IVN
--
USB Power Interface
11
USB_DM
--
USB2.0 Signal Negative
12
USB_DP
--
USB2.0 Signal Positive
For type VI device, you should use the supplied cable, as shown below, to wire the device.
The cable has a 15-pin connector for connecting with the device, and a USB interface for
connecting with the PC.
Figure 4-11 Cable for Type VI Device
Type VII Device
Type VII device with USB interface has a cable with 10-pin RJ45 female connector. It is
recommended to use the supplied cable, as shown below, in the package when using the
device. The supplied cable has a RJ45 male connector for connecting the device, and a USB
interface for connecting external devices.
Figure 4-12 Cable for Type VII Device with USB Interface