ID2000 Series Industrial Code Reader User Manual
23
Chapter 5 Installation
5.1 Installation Preparation
You need to prepare following accessories before installation.
Table 5-1 Accessories
It refers to the supplied cable that is included in the
package. Refer to section Connector and Cable for
details.
You should select suitable power adapter or switch
power supply according to the device power supply and
consumption. You need to purchase separately.
5.2 Install Device
Before You Start
●
Make sure that the device in the package is in good condition and all assembly parts are
included.
●
Make sure that all related equipment is powered off during the installation.
Caution
●
Device with USB data interface may have a risk if it uses power supply of USB2.0 500 mA,
and it is recommended to use USB3.0 power supply.
●
Some models of the devices’ supplied cable have power open line, which has the same
function of DB9 connector to power the device. Do not use them at the same time.
Otherwise, damaging to power supply may occur.
●
When using industrial switching power supply for power supply, pay attention to the
following matters:
○
Before executing any installation or maintenance work, ensure that the power supply is
separated from the main electric supply, and that it will not be suddenly or wiring
problems connected to the main electric supply again.
○
Do not install the power supply in a humid environment, near liquids, high temperature
environment, and direct sunlight or near fire sources.
To Next Page
Loading...