ID2000 Series Industrial Code Reader User Manual
24
○
The industrial switching power supply has exposed high-voltage terminals, please
install it in a closed chassis or cabinet to prevent accidental contact with personnel.
○
The internal components of the power supply should maintain sufficient insulation
distance between the mounting screws.
○
The fan and the cooling hole position cannot have any shelter. If the adjacent equipment
belongs to the heat source, it must keep a distance of at least 10 cm to 15 cm from the
equipment.
○
Please ensure that the power supply is grounded as required before use.
○
When using the power supply, do not exceed the upper limit of its output current and
power. Refer to the power supply nameplate parameters for details.
○
Non-standard installation or use of the power supply in a high temperature environment
will increase the temperature of internal components, resulting in a decrease in output
power.
○
The power supply contains a high-voltage dangerous circuit. If there is any abnormality,
please be sure to cut off the power first and hand it over to a technician with electrical
professional qualification. Please do not open the outer cover by yourself.
○
Do not touch the power terminal within 5 minutes after the power is cut off. Otherwise,
it may cause electric shock.
Steps
1. Use supplied screws to fix the device to the installation position.
2. Use the supplied cable to wire the device according to pin definition mentioned in section
Connector and Cable.
●
For type I to type V devices with fast Ethernet interface, connect the 17-pin M12 connector
of the cable to the device, insert RJ45 connector of the cable into a switch or a PC for
debugging images or transmitting data, and connect DB9 connector to a proper power
adapter for power supply.
●
For type VI device with fast Ethernet interface, connect the DB15 connector of the cable
to the device, insert RJ45 connector of the cable into a switch or a PC for debugging
images or transmitting data, and connect DB9 connector to a proper power adapter for
power supply.
●
For type I to type V devices with USB Interface, connect the 17-pin M12 connector of the
cable to the device, and connect the USB interface of the cable to the PC.
●
For type VI device with USB interface, connect the device to the supplied cable via the
DB15 connector, and connect the USB interface of the cable to the PC.
●
For type VII device with USB interface, insert RJ45 male connector of the cable into the
device, and connect USB interface to external devices.
●
For type VII device with RS-232 interface, insert RJ45 male connector of the cable into the
device, and connect RS-232 interface to external devices.
To Next Page
Loading...
