ID2000 Series Industrial Code Reader User Manual
62
9.3.6 Set Self-Adaptive Adjustment
The function of self-adaptive adjustment can automatically adjust exposure, gain, Gamma
and other parameters to have a better code reading effect.
Note
The function of self-adaptive adjustment may differ by device models.
Steps
1. Go to Image Settings → Smart Tune Control → Self Adapt Adjust, and unfold Self
Adapt Adjust.
2. Select Adjust Source according to actual demands.
Figure 9-15 Select Adjust Source
●
Default Param: It adjusts the default parameters.
●
Polling Param: It adjusts parameters configured in polling. After Polling Param is selected
as Adjust Source, you should select a polling parameter group from Polling Param and
enable or disable Focus Enable.
Figure 9-16 Polling Parameter
3. Set Exposure Max or Gain Max according to actual demands.
●
Exposure Max: It sets the max. exposure during the self-adaptive adjustment.
●
Gain Max: It sets the max. gain during the self-adaptive adjustment.
4. (Optional) Set self-adaptive code type in Code Type Mode.
●
Code Self-Adaptive: All code types added in field of view will be self-adaptive.
To Next Page
Loading...
