ID2000 Series Industrial Code Reader User Manual
58
Figure 9-11 Smart Tune Start
4. (Optional) View smart tune process via Smart Tune Status.
5. Click Execute in Stop Tune to stop smart tune process.
9.3.5 Set Focus
The device supports the focus function according to the code position in the field of view.
Currently, three types of focus are supported, including global auto focus, global manual
focus, and ROI focus.
Note
●
Make sure that the device’s operation mode is test before performing focus, and switch
to the normal operation mode after the focus is completed.
●
The focus function may differ by device models.
Global Auto Focus
The global auto focus allows you to adjust lens focus in a global field of view just by once.
Steps
1. Go to Image Settings → Smart Tune Control → Focus Param → Focus Mode Selector,
and select Whole Area Focus as Focus Mode Selector.
To Next Page
Loading...
