HikRobot ID2000 Series - Contrast Control Settings

ID2000 Series Industrial Code Reader User Manual
92
9.8.12 USB
If you select USB as the communication protocol, you can configure the following
parameters:
Table 9-18 USB Communication Protocol
Parameter
Description
USB Enable
If enabled, the code reader will output data via USB.
USB Output
It sets the USB output mode, including CDC and HID.
USB Baudrate
It is 9600 by default.
USB Data Bits
It is 8 by default.
USB Parity
It is No Parity by default.
USB Stop Bits
It is 1 by default.
9.9 Data Processing Settings
In Data Processing, you can set filter rules for reading codes and other data processing
related parameters.
Note
The specific parameters may differ by device models and firmware versions.
9.9.1 Set Filter Rule
You can set rules via Filter Rule to filter unwanted codes to improve the reading efficiency.
Normal Filter Mode
If the device’s operation mode is normal, trigger mode is on, filter mode is normal, and you
can set following parameters according to actual demands:
● Instant Output Mode Enable: If enabled, the device will output barcode data immediately
once a code is read. If not enabled, the barcode data will be outputted after the device
trigger process ends.
Note
The parameter is only available when the running mode is set to Normal mode and the
trigger mode is enabled.
● Min. Output Time(ms) : Define the minimum time duration (unit: ms) for data output. The
duration starts from trigger time. Note: The parameter is only available when the running