ID2000 Series Industrial Code Reader User Manual
81
according to actual demands.
Note
The range of Maximum Output Limited Time is between 0 ms and 10000 ms.
Figure 9-34 Stop Trigger via Timeout Duration
Stop Trigger via Code Number
This function means that the code quantity outputted by the device is restricted to the
settings you configured here.
You can enable CodeNum Stop Trigger Enable, and set CodeNum Stop Trigger Min and
CodeNum Stop Trigger Max according to actual demands.
Note
●
If the outputted code quantity is smaller than configured CodeNum Stop Trigger Min, and
the device will output codes continuously.
●
If the outputted code quantity is smaller than configured CodeNum Stop Trigger Max, and
the device will stop outputting codes.
●
If the outputted code quantity is between configured CodeNum Stop Trigger Min and
CodeNum Stop Trigger Max, and the device will read and output codes according to
trigger signals.
●
If CodeNum Stop Trigger Min is same with CodeNum Stop Trigger Max, and the device
will stop outputting codes when the number of outputted codes reaches the configured
number.
Figure 9-35 Stop Trigger via Code Number
To Next Page
Loading...
