HikRobot ID2000 Series - Device with RS-232 Interface

ID2000 Series Industrial Code Reader User Manual
12
No.
Signal
I/O Signal Source
Description
Supplied Cable
6
MDI0+
--
Fast Ethernet signal
MDI0+
RJ45 Ethernet
connector
7
MDI1-
--
Fast Ethernet signal
MDI1-
RJ45 Ethernet
connector
8
GPIO2
Line 2+
It can be configured as
input or output, and is
output by default.
Blue/white open line
9
GND
Line 0/1/2/3-
signal ground
Signal common port
Blue open line
10
GPIO3
Line 3+
It can be configured as
input or output, and is
output by default.
Brown/white open line
11
GND
--
Direct current power
supply negative
Black open line
12
Reserved
13
Reserved
Purple open line
14
MDI0-
--
Fast Ethernet signal
MDI0-
RJ45 Ethernet
connector
15
MDI1+
--
Fast Ethernet signal
MDI1+
RJ45 Ethernet
connector
16
GPIO0
Line 0+
It can be configured as
input or output, and is
input by default.
Gray open line
17
GPIO1
Line 1+
It can be configured as
input or output, and is
input by default.
White open line
Table 4-2 Pin Definitions (Type V Device)
No.
Signal
I/O Signal Source
Description
Supplied Cable
1
DC_PWR
--
Direct current power
supply positive
Red open line
2
OUT_COM
LineOut 0/1
signal ground
Output common port
Brown open line
3
Reserved
4
RS232TX
--
RS-232 serial port output
DB9 female serial port