HikRobot ID2000 Series - Page 22

ID2000 Series Industrial Code Reader User Manual
13
No.
Signal
I/O Signal Source
Description
Supplied Cable
5
RS232RX
--
RS-232 serial port input
DB9 female serial port
6
MDI0+
--
Fast Ethernet signal
MDI0+
RJ45 Ethernet
connector
7
MDI1-
--
Fast Ethernet signal
MDI1-
RJ45 Ethernet
connector
8
OPTO_OUT0
LineOut 0 signal
line
Opto-isolated output 0
Blue/white open line
9
IN_COM
LineIn 0/1 signal
ground
Input common port
Blue open line
10
OPTO_OUT1
LineOut 1 signal
line
Opto-isolated output 1
Brown/white open line
11
GND
--
Direct current power
supply negative
Black open line
12
Reserved
13
Reserved
Purple open line
14
MDI0-
--
Fast Ethernet signal
MDI0-
RJ45 Ethernet
connector
15
MDI1+
--
Fast Ethernet signal
MDI1+
RJ45 Ethernet
connector
16
OPTO_IN0
LineIn 0 signal
line
Opto-isolated input 0
Gray open line
17
OPTO_IN1
LineIn 1 signal
line
Opto-isolated input 1
White open line
For type II and the type V devices, you should use the supplied 17-pin cable below to wire
them. The cable has a 9-pin serial port connector that corresponds to 4th and 5th pins of
the 17-pin M12 connector, and a RJ45 connector that corresponds to 6th, 7th, 14th, and 15th
pins of the 17-pin M12 connector.