ID2000 Series Industrial Code Reader User Manual
14
Figure 4-2 17-Pin Cable for Type II and Type V Devices
Note
●
For type II device, the pink line in the open line is Line 0/1’s pull-up and pull-down resistor,
and black/white line in the open line is Line 2/3’s pull-up and pull-down resistor.
●
For type V device, the pink line in the open line is LineIn 0/1’s pull-up and pull-down resistor,
and black/white line in the open line is LineOut 0/1’s pull-up and pull-down resistor.
Caution
You cannot use the 12 V power plug of the 9-pin serial port connector and power supply
open line at the same time. Otherwise, damaging to power supply may occur.
Type III, Type I and Type IV Devices
Type III, type I and type IV devices all have a 17-pin M12 connector, and their corresponding
connector pin definitions are the same.
Figure 4-3 17-Pin M12 Connector
Table 4-3 Pin Definitions (Type III, Type I and Type IV Devices)
To Next Page
Loading...