HikRobot ID2000 Series - Page 24

ID2000 Series Industrial Code Reader User Manual
15
No.
Signal
I/O Signal Source
Description
Supplied Cable
2
Reserved
Brown open line
3
Reserved
4
RS232_TX
--
RS-232 serial port output
DB9 female serial
port
5
RS232_RX
--
RS-232 serial port input
DB9 female serial
port
6
MDI0+
--
Fast Ethernet signal MDI0+
RJ45 Ethernet
connector
7
MDI1-
--
Fast Ethernet signal MDI1-
RJ45 Ethernet
connector
8
GPIO2
Line 2+
Non-isolated input
Blue/white open
line
9
GND
--
--
Blue open line
10
GPIO3
Line 3+
Non-isolated output
Brown/white
open line
11
GND
Line 0/1/2/3-
Direct current power supply
negative
Black open line
12
Reserved
13
Reserved
Purple open line
14
MDI0-
--
Fast Ethernet signal MDI0-
RJ45 Ethernet
connector
15
MDI1+
--
Fast Ethernet signal MDI1+
RJ45 Ethernet
connector
16
GPIO0
Line 0+
It can be configured as input
or output, and is input by
default.
Gray open line
17
GPIO1
Line 1+
It can be configured as input
or output, and is input by
default.
White open line
For type III, type I and type IV devices, you should use the supplied 17-pin cable below to
wire them. The cable has a 9-pin serial port connector that corresponds to 4th and 5th pins
of the 17-pin M12 connector, and a RJ45 connector that corresponds to 6th, 7th, 14th, and
15th pins of the 17-pin M12 connector.