HikRobot ID2000 Series - Chapter 6 I;O Electrical Feature and Wiring; I;O Electrical Feature and Wiring of Type V Device

ID2000 Series Industrial Code Reader User Manual
16
Figure 4-4 17-Pin Cable for Type III, Type I and Type IV Devices
Note
Regarding the cable, black/white line in the open line is Line 0’s pull-up and pull-down
resistor, pink line is Line 1’s pull-up and pull-down resistor, orange line is Line 2’s pull-up and
pull-down resistor, and purple/white line is Line 3’s pull-up and pull-down resistor.
Caution
You cannot use the 12 V power plug of the 9-pin serial port connector and power supply
open line at the same time. Otherwise, damaging to power supply may occur.
Type VI Device
Type VI device has a DB15 connector. Refer to the figure and table below for connector pin
definitions.
Figure 4-5 DB15 Connector
Table 4-4 Pin Definitions (Type VI Device)
No.
Signal
I/O Signal Source
Description
Supplied Cable
1
POWER_IN
--
Direct current power supply
positive
DB9 male serial port
2
RS232_TX
--
RS-232 serial port output
DB9 male serial port
3
RS232_RX
--
RS-232 serial port input
DB9 male serial port
4
GND
Line 0/1/2/3-
Direct current power supply
negative
6-pin terminal