HikRobot ID2000 Series - Page 26

ID2000 Series Industrial Code Reader User Manual
17
No.
Signal
I/O Signal Source
Description
Supplied Cable
5
OPTO_IN0
LineIn 0+
Non-isolated input 0
6-pin terminal
6
TX+
--
Fast Ethernet signal TX+
RJ45 Ethernet
connector
7
RX-
--
Fast Ethernet signal RX-
RJ45 Ethernet
connector
8
OPTO_OUT
LineOut 2+
Non-isolated output 2
6-pin terminal
9
Reserved
10
IO_2
LineOut 3+
Non-isolated output 3
6-pin terminal
11
Reserved
12
Reserved
13
IO_1
LineIn 1+
Non-isolated input 1
6-pin terminal
14
TX-
--
Fast Ethernet signal TX+
RJ45 Ethernet
connector
15
RX+
--
Fast Ethernet signal RX-
RJ45 Ethernet
connector
For type VI device, you should use the supplied cable, as shown below, to wire the device.
The cable has a DB9 female serial port that corresponds to 1st, 2nd, and 3rd pins of the
device’s DB15 connector, and a 6-pin terminal that corresponds to 4th, 5th, 8th, 10th, and
13th pins of the device’s DB15 connector, and a RJ45 connector that corresponds to 6th,
7th, 14th, and 15th pins of the device’s DB15 connector.
Figure 4-6 Cable for Type VI Device