HikRobot ID2000 Series - Diagnose Event Report

ID2000 Series Industrial Code Reader User Manual
95
Table 9-19 Filter Rule Parameters
Parameter
Description
Rule Name
The default rule name is Rule 1, and you can edit it according to actual
demands.
Length Limit
It sets the length range of the code, and its upper limit is 256.
Start With
It sets the specific start with code. You can use semicolon to separate if there
are multiple characters.
Note
If multiple characters are used, code meeting one of these characters is valid.
End With
It sets the specific end with code. You can use semicolon to separate if there
are multiple characters.
Note
If multiple characters are used, code meeting one of these characters is valid.
Not Start With
It excludes the specific start with code. You can use semicolon to separate if
there are multiple characters.
Note
If multiple characters are used, code meeting one of these characters is valid.
Not End With
It excludes the specific end with code. You can use semicolon to separate if
there are multiple characters.
Note
If multiple characters are used, code meeting one of these characters is valid.
Included
It sets the code with specific content. You can use semicolon to separate if
there are multiple characters.
Note
If multiple characters are used, code meeting all these characters is valid.
Excluded
It sets the code without specific content. You can use semicolon to separate if
there are multiple characters.
Note
If multiple characters are used, code meeting all these characters is valid.
Other
Conditions
You can select uppercase, lowercase, digit or Chinese.