ID2000 Series Industrial Code Reader User Manual
2
meet the Limited Power Source (LPS) requirements. For specific requirements, please
refer to the device's technical specifications.
●
It is strictly forbidden to wire, maintain, and disassemble the device is powered on.
Otherwise, there is a danger of electric shock.
●
Make sure that the device is installed in good condition, the wiring is firm, and the power
supply meets the requirements before powering on the device.
●
Looking directly at the device may cause harm to the eyes. Protective measures like
wearing protective glasses should be taken in the process of installation, maintenance
and debugging.
●
If the device emits smoke, odor or noise, please turn off the power and unplug the power
cord immediately, and contact the dealer or service center in time.
●
It is strictly forbidden for non-professional technicians to detect signals during device
operation, otherwise it may cause personal injury or device damage.
●
Avoid aiming the lens at strong light such as lighting, sunlight, or laser beams, etc.,
otherwise the image sensor will be damaged.
●
It is forbidden to touch the image sensor directly. If necessary, please moisten a soft clean
cloth with alcohol and gently wipe off the dust. When the device is not in use, please add
a dust cover to protect the image sensor.
●
If the device does not work properly, please contact your dealer or the nearest service
center. Never attempt to disassemble the device yourself. We shall not assume any
responsibility for problems caused by unauthorized repair or maintenance.
●
Caution: If the device has battery, risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the instructions.
●
Please dispose of the device in strict accordance with the relevant national or regional
regulations and standards to avoid environmental pollution and property damage.
Note
●
Check whether the device's package is in good condition, whether there is damage,
intrusion, moisture, deformation, etc. before unpacking.
●
Check the surface of the device and accessories for damage, rust, bumps, etc. when
unpacking.
●
Check whether the quantity and information of the device and accessories are complete
after unpacking.
●
Store and transport the device according to the storage and transport conditions of the
device, and the storage temperature and humidity should meet the requirements.
●
It is strictly prohibited to transport the device in combination with items that may affect
or damage the device.
●
The device should not be placed with exposed flame sources, such as lighted candles.
●
Please read the manual and safety instructions carefully before installing the device.
●
Quality requirements for installation and maintenance personnel:
○
Qualification certificate or working experience in weak current system installation and
maintenance, and relevant working experience and qualifications. Besides, the
personnel must possess the following knowledge and operation skills.
○
The basic knowledge and operation skills of low voltage wiring and low voltage
electronic circuit connection.
To Next Page
Loading...