4. Set the evaluation value for A/B/C/D grade according to actual demands.
Note
●
If the actual code reading value of the device is greater than the grade A evaluation value,
and then the evaluation standard is grade A. If the actual code reading value is between
grade A and grade B, and then the evaluation standard is grade B. If the actual code
reading value is between grade B and grade C, and then the evaluation standard is grade
C. If the actual code reading value is between grade C and grade D, and then the evaluation
standard is grade D. If the actual code reading value is lower than the D grade, and then
the evaluation standard is F grade.
●
The client software selects the worst grade among all the evaluation standards as the
grade judgment result of the code. The A grade means that the code quality is best, and
F grade means that code quality is worst.
5. Enable Aperture Enable and enter Aperture according to the smallest size of codes.
6. (Optional) Set Quality 1D Max Num to configure the amount of code to be evaluated. If
the actual amount of code exceeds the configured, the later codes will not be evaluated.
7. (Optional) Go to Algorithm Control → Rating Standard 1D Enable, set enable Rating
Standard 1D Enable, and select 1D Rating Standard.
Note
For example, if 1D Rating Standard is C, and then the client software will output codes with
A/B/C grade and codes with D/F will be filtered.
7. Click to start acquisition, and the client software will display the overall code quality
in the history record area.
Figure 9-25 Overall Code Quality
Set 2D Code Quality Evaluation
The 2D quality evaluation function uses the ISO15415 standard to judges the quality of
To Next Page
Loading...
