Model Identification
Chapter 1: Introduction
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 1 - 3
Service Manual (MAN272 REV 4)
1
Model Identification
For bed model identification, see table 1-1 on page 1-3.
Table 1-1. Model Identification
Safety Tips
Train and educate your staff on the hazards associated with electric beds. Do
not allow personnel to have their entire body below the sleep surface and
within the confines of the bed. Unplug the bed from its power source and
engage the lockout control prior to cleaning or servicing it. If service personnel
need to get under the bed, they must block up the hilow portion as an added
precaution. Ensure that the foot section is properly mounted to the yoke.
We urge you to incorporate these safety tips into your procedures for the safety
of both patients and staff.
Bed Position
To reduce the severity of falls by patients, always leave the bed in the low
position when the patient is unattended.
Siderails
Leave the siderails fully up and locked when the patient is left unattended.
When raising the siderails, be sure that you hear the click that signals the up
and locked condition. Give the siderails a tug to check that they are firmly in
position.
Siderails are intended as a reminder, not a restraint device. Appropriate
medical personnel should determine the level of restraint necessary to ensure a
patient remains safely in bed.
Model Number Description
P3700A Affinity® Three Birthing Bed
P3700B Affinity® Four Birthing Bed, introduces Stow and
Go® Retractable Foot Section
P3700C Affinity® Four Birthing Bed, updated foot section
P3700D Affinity® Four Birthing Bed, introduces transport
handles
To Next Page
Loading...
