Hill-Rom Affinity Three - Brake Caster Malfunction

2.11 Brake Caster Malfunction
Chapter 2: Troubleshooting Procedures
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 2 - 27
Service Manual (MAN272 REV 4)
2
2.11 Brake Caster Malfunction
1. The brake caster pedal locks in the brake position when you push on it with
your foot.
Yes No
Inspect the caster for excessive wear. If necessary, replace the
damaged caster (refer to procedure 4.32). If this solves the
problem, go to “Final Actions” on page 2-10. Otherwise, go to
step 2.
2. The casters lock in the brake position and do not roll or rotate when you
push in the brake pedal.
Yes No
Adjust the caster assembly (refer to procedure 4.32). If this
solves the problem, go to “Final Actions” on page 2-10.
Otherwise, go to step 3.
3. Another part of the bed interferes with the brake mechanism.
Yes No
If the brakes still do not work, contact Hill-Rom Technical
Support.
4. Take appropriate actions to eliminate the interference.
This solves the problem.
Yes No
Contact Hill-Rom Technical Support.
5. Go to “Final Actions” on page 2-10.