Hill-Rom Affinity Three - Air System Functional Check; Other Bed Functional Checks

Function Checks
Chapter 2: Troubleshooting Procedures
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 2 - 9
Service Manual (MAN272 REV 4)
2
Yes No
Go to RAP 2.7.
Air System Functional Check
1. Press the seat inflate button, and activate the bed air surface. The seat
section mattress inflates.
Yes No
Go to RAP 2.12.
2. Press and hold the seat deflate button, and activate the bed air surface. The
seat section mattress deflates.
Yes No
Go to RAP 2.12.
3. Press the back inflate button, and activate the bed air surface. The lumbar
section inflates.
Yes No
Go to RAP 2.12.
4. Press the back deflate button to activate the bed air surface. The lumbar
section deflates.
Yes No
Go to RAP 2.12.
Other Bed Functional Checks
1. The lockout switch locks out the designated inboard/outboard controls
when placed in the “OFF” position (locked), and enables the functions
when placed in the “ON” position (unlocked). The lockout functions work
properly.
Yes No
Replace the faulty rocker switch (refer to procedure 4.26). If this
solves the problem, go to “Final Actions” on page 2-10.
Otherwise, contact Hill-Rom Technical Support.