Preventive Maintenance
Chapter 6: General Procedures
Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 6 - 9
Service Manual (MAN272 REV 4)
6
Inspect for the Labor Grip Plugs
Tools required: None
1. Look on both sides of the bed and make sure there is a plug in the holes on
the outside of the labor grip arms (see figure 6-3 on page 6-9).
Make sure the labor grip plugs are installed. If they are not, personal
injury could occur.
2. If either hole does not have a plug, call Hill-Rom Technical support for a
replacement.
Figure 6-3. Labor Grip Plugs
To Next Page
Loading...
