Hill-Rom Affinity Three - Night Light Does Not Illuminate

2.13 Night Light Does Not Illuminate
Chapter 2: Troubleshooting Procedures
Page 2 - 34 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed
Service Manual (MAN272 REV 4)
2.13 Night Light Does Not Illuminate
1. The night light comes on when the ambient light dims.
Yes No
Replace the lamp bulb or fixture if damaged (refer to procedure
4.13). If this solves the problem, go to “Final Actions” on page
2-10. Otherwise, continue to step 2.
2. Verify that the photocell functions. The night light comes on when the
ambient light dims.
Yes No
Replace the photocell. If this solves the problem, go to “Final
Actions” on page 2-10. Otherwise, continue to step 3.
3. The system functions normally.
Yes No
Verify that the night light lamp cable is plugged into the logic
control P.C. board connector, P1. If this solves the problem, go
to “Final Actions” on page 2-10. Otherwise, continue to step 4.
4. The system functions normally.
Yes No
Replace the logic control P.C. board (refer to procedure 4.23).
If this solves the problem, go to “Final Actions” on page 2-10.
Otherwise, contact Hill-Rom Technical Support.
5. Go to “Final Actions” on page 2-10.