Hill-Rom Affinity Three - Chapter 6: General Procedures; Cleaning

Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 6 - 1
Service Manual (MAN272 REV 4)
6
Chapter 6
General Procedures
Cleaning
WARNING:
Follow the product manufacturer’s instructions. Failure to do so could
result in personal injury or equipment damage.
SHOCK HAZARD:
Unplug the unit from its power source. Failure to do so could result in
personal injury or equipment damage.
SHOCK HAZARD:
Do not expose the unit to excessive moisture which would allow liquid
to pool. Personal injury or equipment damage could occur.
CAUTION:
Do not use harsh cleansers or detergents such as scouring pads and
heavy-duty grease removers, or solvents such as toluene, xylene, and
acetone. Equipment damage could occur.
CAUTION:
Ensure that the metal platform is dry before placing the mattress back
onto the bed. Failure to do so could result in equipment damage.
If there is no visible soilage with possible body fluids, we recommend that you
clean the unit with a mild detergent and warm water. If disinfection is desired,
you may use a combination cleanser/disinfectant as explained in
“Disinfecting” on page 6-2. In either case, ensure that the metal platform is dry
before placing the mattress back onto the bed.
Steam Cleaning
Do not use any steam cleaning device on the unit. Excessive moisture can
damage mechanisms in this unit.