Hill-Rom Affinity Three - Chapter 4: Removal, Replacement, and Adjustment Procedures; Tool and Supply Requirements

Affinity® Three Birthing Bed and Affinity® Four Birthing Bed Page 4 - 1
Service Manual (MAN272 REV 4)
4
Chapter 4
Removal, Replacement, and
Adjustment Procedures
Tool and Supply Requirements
To service the bed, the following tools and supplies are required:
• Digital or analog multimeter (VOM)
• Ratchet
• T10 Torx® head bit
• T25 Torx® head bit
• 7/16" socket
•¾" socket
• 5/16" wrench
• 7/16" wrench
• ½" wrench
• 11/16" wrench
• Adjustable wrench
• 3/32" Allen™ wrench
• 5/32" Allen™ wrench
• Small screwdriver
• Short phillips head screwdriver
• Needle nose pliers
• External snap-ring tool
• E-ring tool
• Split-ring tool
• Small wire cutters
•Hammer
• 1/8" drift punch