Hill-Rom Affinity Three - Trend-Like Position Malfunction

2.15 Trend-Like Position Malfunction
Chapter 2: Troubleshooting Procedures
Page 2 - 36 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed
Service Manual (MAN272 REV 4)
2.15 Trend-Like Position Malfunction
1. If unable to place the bed in the Trend-Like position, press the hilow up
switch to raise the bed to a higher position. Push down on the Trend-Like
position release handle. The head end is 8° below the foot end.
Yes No
Verify that the Trend-Like position release handles are properly
adjusted and functional. See “Trend-Like Position Sensing
Switch” on page 4-28 for access and safety precautions in
servicing the Trendelenburg features. If this solves the problem,
go to “Final Actions” on page 2-10. Otherwise, contact Hill-
Rom Technical Support.
2. Go to “Final Actions” on page 2-10.