Hill-Rom Affinity Three - Foot System Functional Check

Function Checks
Chapter 2: Troubleshooting Procedures
Page 2 - 8 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed
Service Manual (MAN272 REV 4)
Foot System Functional Check
1. Place the bed in the following positions:
• Position the bed in the mid-height position with the hilow function.
• Use the foot function to raise the foot section until the mattress is level with
the seat section mattress.
• Lower the head section to the low position with the head function.
• Ensure that the bed is out of the Trend-Like position (the sleep surface is
level).
2. Press the foot up switch, and activate the foot section. The foot section
rises when the foot up switch is activated.
Yes No
Go to RAP 2.8.
3. Press the foot down switch. The foot section lowers when the foot down
switch is activated.
Yes No
Go to RAP 2.9.
4. Raise the foot section to the high position using the foot up switch. The top
of the foot section stops approximately 2-1/2" (6.35 cm) above the seat
section.
Yes No
Adjust the foot limit switch (refer to procedure 4.7). If this solves
the problem, go to “Final Actions” on page 2-10. Otherwise,
contact Hill-Rom Technical Support.
5. Lower the foot section to the low position with the foot down switch. The
foot drive stops when the foot lift arm is 1/4" (6.4 mm) above the foot end
hilow lift arm (see figure 4-10 on page 4-23).
Yes No
Adjust the foot limit switch (refer to procedure 4.7). If this solves
the problem, go to “Final Actions” on page 2-10. Otherwise,
contact Hill-Rom Technical Support.
6. Lower the bed to the low position with the hilow down switch. Lower the
foot section with the foot down switch. The bed automatically rises from
the low position.
Yes No
Go to RAP 2.10.
7. Activate the foot up or down switch. The foot motor is free of excessive
noise or any mechanical binding/grinding.