1-53
OPERATOR'S STATION
Auto Shut-Down
d
WARNING: This function automatically stops the
engine. Pay extra attention to the work and work
environment when using this function.
The auto shut-down function can be set in this screen. Set
the auto shut-down time and enable (ON) the function
beforehand. The engine automatically stops after the preset
time at the state in which the pilot control shut-off lever
is pulled. 30 seconds before the engine stop, the monitor
displays a message that engine will be stopped and the
indicator starts flashing. The buzzer also sounds. The buzzer
sounds once at 30 seconds before, and sounds continuously
from 15 seconds before the stoppage. The engine speed
decreases to the idling speed, and then stops after 15 seconds.
When the pilot control shut-off lever is pushed before
stopping the engine, the auto shut-down is disabled and the
engine will not stop.
IMPORTANT: When the engine is stopped by the auto
shut-down function, turn the key switch to ACC or OFF
once, then turn it to START to restart the engine. Turn
the key switch OFF after auto shut-down when leaving
the machine for long period of time. Do not leave the
machine after auto shut-down. Failure to do so may
discharge the batteries.
Auto Shut-Down: ON/OFF
1. Push selector knob (2) while displaying Basic Screen (1)
to display Main Menu screen (3).
2. Rotate selector knob (2) to highlight Setting Menu (4).
3. Push selector knob (2) to display Setting Menu screen
(5).
4. Rotate selector knob (2) to highlight Auto Shut-Down (6).
1
3
4
5
6
2
MDAA-01-114EN
MDC1-01-147EN
MDC1-01-001
MDCD-01-026
To Next Page
Loading...
Need help?
General
