5-13
OPERATING THE MACHINE
The selected work mode is indicated by attachment mode
indicator (2) on Basic Screen (1).
Select the work mode corresponding to the work in which the
machine is engaged, referring to the table below.
Work Mode Description
Digging Mode Select this mode when using bucket.
Breaker 1 to 5 Mode Select this mode when using breaker.
Pulverizer 1 to 5 Mode Select this mode when using pulverizer.
Crusher 1 to 5 Mode Select this mode when using crusher.
Vibrating Hammer 1 to 5
Mode
Select this mode when using vibrating hammer.
Grapple 1 to 5 Mode Select this mode when using grapple.
Clamshell 1 to 5 Mode Select this mode when using clamshell.
Thumb 1 to 5 Mode Select this mode when using thumb.
Tilting Rotator 1 to 5 Mode Select this mode when using tilting rotator.
Tilting Bucket 1 to 5 Mode Select this mode when using tilting bucket.
Others 1 to 5 Mode Select this mode when other than the above attachment is used.
f
NOTE: 51 work modes shown above are designated
as standard specifications. Up to 11 attachment modes
other than digging mode can be designated. Consult your
authorized dealer for adding or changing the designation of
the attachment modes.
1
2
MDC1-01-001
To Next Page
Loading...
Need help?
General
