6-4
TRANSPORTING
3. When the front attachment is fitted
3.1 Determine a position for the bucket in line with the
trailer. Adjust the angle of the boom and the arm at 90
to 110 °.
3.2 Lower the bucket onto to the deck of the trailer before
the machine passes over the end of the ramp for
support.
3.3 Lift the bucket slightly off the deck of the trailer after
the machine has moved to the designated space.
With the arm lifted inwards, slowly swing the upper
structure place around 180 °.
3.4 Rest the front attachment on supports such as wooden
blocks placed on the trailer flatbed. Also lower the
blade onto the deck at this time (if fitted).
4. Stop the engine. Remove the key from the key switch.
5. Pull the pilot control shut-off lever to the LOCK position.
6. Close cab windows, roof vent and door, and cover the
exhaust opening, to prevent entry of wind and water.
Place a cover over the exhaust outlet. Lock all doors,
covers and caps if they have a lock.
7. Store all mirrors and the radio antenna correctly.
M107-06-012
M107-06-013
15 ° or less
To Next Page
Loading...
Need help?
General
