Voyager 1602g User Guide 89
(if turned on) for each read. The scanner attempts to find and decode new symbols
as long as the scan button is pressed. When this programming selection is turned
Off, the scanner will only read the symbol closest to the aiming beam. Default = Off.
No Read
With No Read turned On, the scanner notifies you if a code cannot be read. If using
an EZConfig for Scanning Tool Scan Data Window (see page 173), an “NR” appears
when a code cannot be read. If No Read is turned Off, the “NR” will not appear.
Default = Off.
If you want a different notation than “NR,” for example, “Error,” or “Bad Code,” you
can edit the output message (see Data Format). The hex code for the No Read sym-
bol is 9C.
Video Reverse
Video Reverse is used to allow the scanner to read barcodes that are inverted. The
Video Reverse Off barcode below is an example of this type of barcode. Scan
Video Reverse Only to read only inverted barcodes. Scan Video Reverse and Stan-
dard Barcodes to read both types of codes.
Note: After scanning Video Reverse Only, menu barcodes cannot be read. You must scan
Video Reverse Off or Video Reverse and Standard Barcodes in order to read menu
barcodes.
Note: Images downloaded from the unit are not reversed. This is a setting for decoding only.
To Next Page
Loading...
