Voyager 1602g User Guide 21
Programming an Interface for an Access Point
If you are using a Honeywell Access Point (AP01-XXXBT) to communicate with the
VG1602, you can use the following barcodes to program the Access Point interface.
These barcodes set the Access Point for commonly used interfaces.
Keyboard Wedge
If you want your system programmed for an IBM PC AT and compatibles keyboard
wedge interface with a USA keyboard, scan the barcode below, then power cycle the
host. Keyboard wedge is the default interface. This interface is only appropriate for
an Access Point.
Note: The following barcode also programs a carriage return (CR) suffix.
Laptop Direct Connect
For most laptops, scanning the Laptop Direct Connect barcode allows operation
of the scanner in parallel with the integral keyboard. The following Laptop Direct
Connect barcode also programs a carriage return (CR) suffix and turns on Emulate
External Keyboard (page 17). Power cycle the host after scanning this barcode.
This interface is only appropriate for an Access Point.
RS232 Serial Port
The RS232 Interface barcode is used when connecting to the serial port of a PC or
terminal. The following RS232 Interface barcode also programs a carriage return
(CR) and a line feed (LF) suffix, baud rate, and data format as indicated below. It
also changes the trigger mode to manual.
This interface is only appropriate for an
Access Point.
IBM PC AT and Compatibles with
CR suffix
Laptop Direct Connect
with CR suffix
Option Setting
Baud Rate 115,200 bps
Data Format 8 data bits, no parity bit, 1 stop bit
To Next Page
Loading...
