78 Voyager 1602g User Guide
Activation Character
This sets the character used to trigger scanning when using Character Activation
Mode. On the ASCII Conversion Chart (Code Page 1252), find the hex value that
represents the character you want to use to trigger scanning. Scan the following
barcode, then use the Programming Chart to read the alphanumeric combination
that represents that ASCII character. Scan Save to finish.
End Character Activation After Good Read
After a barcode is successfully detected and read from the scanner, the illumina-
tion can be programmed either to remain on and scanning, or to turn off. When
End Character Activation After Good Read is enabled, the illumination turns off
and stops scanning after a good read. If you scan Do Not End Character Activa-
tion After Good Read, the illumination remains on after a good read. Default = End
Character Activation After Good Read.
Character Activation Timeout
You can set a timeout for the length of time the aimer remains on and attempting
to decode barcodes when using Character Activation Mode. Set the length (in milli-
seconds) for a timeout by scanning the following barcode, then setting the timeout
(from 1-300000 milliseconds) by scanning digits from the Programming Chart,
then scanning Save. Default = 30000 ms.
Do Not End Character
Activation After Good Read
* End Character Activation
After Good Read
To Next Page
Loading...
Need help?
General
Weight and Dimensions
