Voyager 1602g User Guide 3
Battery Charge Indicator
When the battery is charging, the small LED at the top left of the scanner flashes
orange. When the battery is fully charged, this LED is solid green. Refer to Scan
LED Sequences and Meaning (page 45) and Low Battery Indicator (page 45) for
the complete list of LED indications.
To use your scanner with a Honeywell Access Point (AP01-XXXBT), refer to Host
ACK Timeout,page 66 or Linking the Scanner to an Access Point,page 55.
Pairing the Scanner with Bluetooth
®
Devices
The scanner can be paired with Bluetooth devices such as personal computers,
laptops, tablets, and Apple® devices.
1. Scan the appropriate Bluetooth Connect barcode below to establish one-way
communication with the Voyager 1602g.
Note: If you want to use an Apple app or you are a developer creating an Apple app to
communicate with the VG1602g, you would use SPP to establish two-way
communication to control the scanner through that application. See Pairing the
Scanner with an Apple Device Using SPP on page 5.
2. Set your personal computer, laptop, tablet, or Apple device so it searches for
other Bluetooth devices. (Refer to your device’s User Guide for pairing
instructions.)
3. Once your personal computer, laptop, tablet, or Apple device has located the
scanner, select the scanner name. Some personal computers, laptops, or
tablets will automatically pair with the scanner. If your device automatically
Bluetooth HID Keyboard
Connect
Bluetooth HID Japanese
Keyboard Connect
To Next Page
Loading...
