Voyager 1602g User Guide 181
The scanner scans until a barcode has been read, until the deactivate command is
sent, or until the serial time-out has been reached (see Read Time-Out on page 75
for a description, and the serial command on page 191).
Reset the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults barcode below. This resets the scanner to the custom default
settings. If there are no custom defaults, it will reset the scanner to the factory
default settings. Any settings that have not been specified through the custom
defaults will be defaulted to the factory default settings.
Note: The Custom Defaults settings apply to all work groups. Scanning the Activate
Custom Defaults barcode also causes both the scanner and the host to perform a
restart and become unlinked. You must relink (pair) the scanner to the host. See
Wireless System Operation for additional information.
The charts on the following pages list the factory default settings for each of the
commands (indicated by an asterisk (*) on the programming pages).
To Next Page
Loading...
Need help?
General
Weight and Dimensions
