Honeywell Voyager 1602g - Gilbarco Terminal Default Settings; Honeywell Bioptic aux Port Configuration; Datalogic Magellan © Bioptic aux Port Configuration

26 Voyager 1602g User Guide
Gilbarco
®
Terminal Default Settings
Scan the following Plug and Play code to program the scanner for a Gilbarco
terminal, then power cycle the host. This barcode sets the baud rate to 2400 bps
and the data format to 7 data bits, even parity, 2 stop bits. It also adds a carriage
return (CR) suffix and programs the following prefixes for each symbology. This
interface is only appropriate for an Access Point.
Honeywell Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Honeywell
bioptic scanner auxiliary port configuration, then power cycle the host. This
barcode sets the baud rate to 38400 bps and the data format to 8 data bits, no
parity, 1 stop bit. This interface is only appropriate for an Access Point.
Datalogic™ Magellan
©
Bioptic Aux Port Configuration
Scan the following Plug and Play code to program the scanner for a Datalogic
Magellan bioptic scanner auxiliary port configuration, then power cycle the host.
This barcode sets the baud rate to 9600 bps and the data format to 8 data bits, no
parity, 1 stop bit. This interface is only appropriate for an Access Point.
Symbology Prefix
UPC-A A
UPC-E E0
EAN-8 FF
EAN-13 F
Gilbarco Settings
Honeywell Bioptic Settings
Datalogic Magellan Bioptic Settings