Voyager 1602g User Guide 47
To use a different scanner, you need to unlink the original scanner by scanning the
Unlink Scanner barcode. (See Unlinking the Scanner, below.)
Open Link Mode - Single Scanner
When newly shipped or defaulted to factory settings, a scanner is not linked to an
Access Point. A link is established when an Access Point linking barcode is
scanned. When in Open Link Mode, a new link is established when you scan an
Access Point linking barcode. Each time a scanner scans an Access Point linking
barcode, the scanner becomes linked to the Access point and the old scanner is
unlinked.
Unlinking the Scanner
If a host has a scanner linked to it, that scanner must be unlinked before a new
scanner can be linked. Once the previous scanner is unlinked, it will no longer com-
municate with the host. To unlink the scanner from a host, scan the Unlink Scan-
ner barcode below.
Override Locked Scanner
If you need to replace a broken or lost scanner that is linked to a host, scan the
Override Locked Scanner barcode below with a new scanner and pair that scanner
with the host. The locked link will be overridden; the broken or lost scanner’s link
with the host will be removed, and the new scanner will be linked.
Out-of-Range Alarm
Note: This feature is only supported by a Honeywell Access Point (AP). See Access Point
Operations, beginning on page 55 for further information.
* Open Link Mode
(Single Scanner)
Override Locked Scanner
(Single Scanner)
To Next Page
Loading...
