52 Voyager 1602g User Guide
To rename scanners with sequential, numeric names, scan the barcodes below.
Scan the Reset code after each name change and wait for the scanner to relink to
the host before scanning a barcode to rename the next scanner.
You may also scan the Scanner Name barcode below and scan a number for the
scanner name. For example, if you wanted to name the linked scanner “312,” you
would scan the barcode below, scan the 3, 1, and 2 barcodes on the Programming
Chart inside the back cover of this manual, then scan Save. Scan the Reset bar-
code and wait for the scanner to relink to the host.
Application Work Groups
Note: Application Work Groups can only be used with an Access Point.
To Next Page
Loading...
