Voyager 1602g User Guide 9
PROGRAMMING THE INTERFACE
Introduction
This chapter describes how to program your scanner for different keyboards and
settings, and for an interface when using an Access Point (see Programming an
Interface for an Access Point, beginning on page 21). The VG1602g is primarily
designed as a cordless scanner. However, if you are using the VG1602g as a corded
scanner, see Programming the VG1602 Corded Interface beginning on page 35.
Keyboard Country Layout
If your interface is USB Keyboard or Keyboard Wedge through an Access Point or a
Bluetooth Keyboard, your keyboard layout default is a US keyboard. To change this
layout, refer to the chart below for your keyboard country. Scan the appropriate
barcode below to change the layout.
By default, national character replacements are used for the following characters:
#$@[\]^‘{|}~
See ISO 2022/ISO 646 Character Replacements on page 220 to view the character
replacements for each country.
Keyboard Countries
To Next Page
Loading...
Need help?
General
Weight and Dimensions
